PROJECT BOAT TRAILER - $200 (BERTHOUD)

condition: fair

make / manufacturer: UNKNOWN

QR Code Link to This Post

The trailer is an old trailer that had been modified to carry a whitewater raft. It is sold for parts and without a title. The trailer tilts for loading the boat. (See photos of the release lever—Red arrow). There are 4 fixtures for 2” X 4” boat bunks but those have been turned 180 degrees on the frame. (See photos, green arrow) I also have a wide roller as shown in the plastic bucket. See photos, purple arrow). LED light fixtures are included but those are faded from the sun. The winch platform can be slid fore and aft to fit your boat. The trailer is approximately 16’ 10” from the ball to the rear of the trailer frame. It is set up at present at 13’ 6” from the winch to the rear of the trailer frame. Trailer frame at its widest point is 45”. Tire size is 4.8 X 8 (Approximately 15 ½” diameter). The tires hold air and are in fair to good condition. I believe the axle can be slid fore and aft to suit your needs as well. The trailer has shock absorbers. Two-inch trailer coupler. Wheels are equipped with bearing buddies. Two spare tires mounted and holding air.

post id: 7932168798

posted: 2026-05-04 16:37

♥ best of ^[?]

reading

writing

saving

searching

refresh the page.

PROJECT BOAT TRAILER - boat parts - by owner - marine sale -...

The trailer is an old trailer that had been modified to carry a whitewater raft. It is sold for parts and without a title. The trailer tilts for loading the boat. (See photos of the release...