favorite
favorite
hide
unhide
flag

Posted

print

Tacoma truck bed deck and drawer system - $450 (Boulder)

Tacoma truck bed deck and drawer system 1 thumbnailTacoma truck bed deck and drawer system 2 thumbnailTacoma truck bed deck and drawer system 3 thumbnailTacoma truck bed deck and drawer system 4 thumbnailTacoma truck bed deck and drawer system 5 thumbnail
condition: excellent
make / manufacturer: N.A.
model name / number: N.A.
size / dimensions: 73" x 57 1/4" x 9 7/8"
This is a home-built deck and drawer system made for a 2020 Toyota Tacoma truck with a 6-foot bed. The truck is a 3rd generation Tacoma, so the deck/drawer system will fit into any 2016 - 2023 Tacoma long bed. I built it using 19/32" plywood for the deck and drawer bottoms, 1x10 pine lumber for the drawer sides and side supports, and a 2x10 for the center support. The drawers fit between the wheel wells and go the entire length of the truck bed. The drawers lie on plywood strips that fit in the grooves in the floor of the truck bed and keep the drawers from rubbing on the bed of the truck. There are four covered compartments with removable lids in front of and behind the wheel wells – two on each side.

The frame fits snugly into the bed of the truck, and does not need any sort of fastening to hold it in place. I can help you install the frame in your truck and then screw down the deck with the supplied deck screws. The installation process will take less than 30 minutes.

I used this system in my truck for four years without a single problem. I am only selling this because I upgraded my truck bed cover from a fiberglass shell to a pop-up cab-over camper and no longer need a deck/drawer system. Similar new commercial systems start at $1600.

post id: 7756297309

posted:

best of [?]

loading
reading
writing
saving
searching